Matto you legend! will 13's fit over this setup?

not sure. i dont have a 13 to try it with

FUUUUUUUUUUUUUUUUUUU!

all good ill suss it out :)

only some 13 inch mags will clear them as they are rather large discs, about 280/290mm i think. bluebirds all run 14s or bigger standard

Thanks Pigdog, I might look into that.

Tru blu conversion?

To think I spent months perfecting the Sigma setup and the blueys where
just staring me in the face all over the place the dirty cheap buggers!!!

So whats up with the trx caliper backing plate (alloy you mentioned???)
or are you using the drum backing plate??? that pic is not clear showing the back.

Would you just be able to use series 3 bluebird rear setup aswell? i take it they would be roughly the same

all of the rwd trx bluebird rear discs are the same

and D he is using the alloy bluebird backing plate and modifying that to suit the 1000 drum bolt patten

oh and just a little bit of info, r31 rear discs go onto a h165 pretty easily, so if h165 discs go on the front of a 1000 easy enough then you would think that r31 rears would also be able to be adapted pretty easily. and you can fit 13s over them piss easily and replace the handbrake caliper with one from a commodore to simplify it a bit
probably a bit more common then trx bluebirds

also. if you want a caliper with a larger piston, im pretty sure that the smaller girlocks(from 200bs i think) go onto the metal part of the bluebird caliper bracket. or atleast the sliding pins were the same distance apart as the bluebird ones(or commodore ones)