everytime you change your plans/ ideas with this thing it gets better and better, great taste this thing will be not only quick but look filth when its done! congrats on it

cheers guys, dont worry there will be pics galore over my week off so stay tuned.

Had a look under the rear before dinner and because of the box angle and how low the rear is ill have to replace the tailshaft tunnel! ah well just another thing to add to the list lol

powder coat the wheels a gloss black.. other than that, time to update that profile pic ;)

Yep the wheels will be pulled apart next week to be done! powdercoating the chrome dish part gloss black and replacing the rivets with stainless cap screws. should tie in nicely with the front..

haha ill get onto the profile pic.. i didnt think of that!

Not a great deal to update.. spent yesterday putting a new turbo on a mates SR powered S13.

Local swap meet today.. managed to stumble across 2x 1200 sedan rear bumpers, $30 each.. managed to take both home for $30! haha cheering.

Swapped my struts left to right and fitted up my brakes, they look pretty sweet and the wheels only just clear them which im pretty happy about.






Also knocked up the new seat rails, only had enough steel for one tho lol, will make the other tomorrow.

Looking good wardy
This is gonna be a prize car!!
Great work more pics!!

cheers Rob.. yes will be more pics throughout the week!

few goodies turned up today!.. was like a kid at christmas

Have 99% of my fuel system now, just need a y-block and a couple of adaptors, then get a stainless piece made for my pumps and surge tank to fit to.

Also got my new clutch from Drew @ Direct Clutch Services.. looks fantastic and i hope to deal with him again in the future

couple of pics-





Also ordered some genuine flywheel bolts from the local mazda dealer..

So this weekends work will include, pulling engine and box, fitting flywheel and clutch, fit brake lines, refit engine and box, cut hole in the inner guard for the turbo to fit. And upon further inspection i have noticed that because of how low it is the tailshaft will foul on the shaft tunnel... so ill be cutting it out and making another one
May also get the fuel lines fitted up

peekaboo

good thing youve already taken the headlight out.. would of sucked it off anyway haha