as above guys yep its time for the trayback shell to go. :( cause ill be getting a new project in next 2 weeks. . their has been alot of work and time put into this ute and it will need a little more then it will be a real looker. .

IT HAS
- no water rails above doors as been welded smooth
- shaved doors as to keep the smooth look
- seam welded and smoothed enginebay (Needs few flat plates welded in)
- rx7 gearbox tunnel
- custom tailshaft loop welded at rear of cab
- welded air vents infront of window
- new radiator suport though some been cut out to weld in smooth panel with front set up to take 600x300x100 intercooler
- back of cab has been continued all the way to the bottom of cab to keep smooth look
- rear chassie has had cross bars replaced and has been fully welded tops on rails
- rear shackle mount as been remounted 50mm up in chassie to give another 2" drop
- and yer comes with front guards great condition no rustfront apron and bonnet bonnet as dent in midle line best to buy new bonnet
- more stuff but come see for urself
-cdi fiberoptic concrete tray with black carpet and pollised alloy boarder and tubs bedded on a steel frame

WHAT THE BODY NEEDS
-where u put ur feet welded back in as i was fitting a chassie box chanel from front chassie to rear and filled with flat floor
- needs 2 metal patches were bumper connects on in the engine bay as i cut these out and didnt get around to replacing them yet
- iv cut middle of the firewall out and cut a flat sheet of metal to be put in their but didnt get round to doing it
-few bits and pieces all and all most the body work that as been done is ready for paint most of shell is in 2pac primer. .

for more info call me Laney on 0402560262 id like offers peeps will just come as shell no diff no struts. . sorry