Hi all long time reader first time poster off this great site. thought id show u guys what i been up to after finally getting off my butt.i built these manifolds last year as practice for my tig welding course. i hope the photos come up, im totally hopeless with computers so if they dont come up there is a heap of photos of the fab work in the engine section, put them there last week(i think thats where they went). anyways thanks for a great site lots of insperation here. cheers josh

Attach file:

---

  a12t7.jpg (104.29 KB)


  a12t6.jpg (97.98 KB)


  a12t3.jpg (103.18 KB)


  a12t8.jpg (83.51 KB)

Nice work mate!

nice one! i remember seeing this in the photo album a week or so ago, looks awesome!


Have you had it running? what boost are yoou running?


don't spare any details!

almost looks high enuff to fit in a 1000... hmmm

Ive been thrashing it for ten months now it runs great.i was so suprised at how hard a stock a12 will go. Does great skids lol. Its a t25 12.15 psi sucking through a 2inch su with the dizzy locked aroud 25°. Never had it dyno'd,wish I did. car is off the road now,motor still runs like new.gunna build a crazy a15 setup c how much hp they can make.

Good work, so is it the same setup going on the A15?

Did you do the "carbon seal" to the turbo or just wack it straight on?
Would like to do the same setup.

Nice setup!!

are you from the Taree area Josh?

The a15 will be a whole new set up just dont know weather to go draw through with e85 or efi yet. didnt do the carbon seal i wasnt sure if the t25 had them as oe or not. im about 30 min north of taree.

Sweet manifolds. This looks like that simple draw through set up everyone dreams of. Go e85 be good to see it done, you would have to find somewhere nearby that sells it though.