Well the B210 USA unit might work too. But we don't know. It will fit the 280ZX struts, and the B310 ball joint (probably) but whether it fits the 1200 tie-rod ends is undocumented.

The normal swap is 210 LCA with balljoints & 210 steering arm.

Crap, I didnt read that part. well ill keep looking. thanks a lot guys :)

Quote:That needs to be corrected. Where did you see it?

In the 280ZX Strut Swap article, I find no mention of B210 steering arms, but it says to use a B310 steering arm.

In Knuckle Arm it lists:
B210: 40052-H7400 (1976-up A engine, except USA)
The "except USA" is important.

Use a steering arm from a 210 (B310). Read the article very carefully, as it gives you more than one option in track width.

Ok so i was reading all the tech wiki and i Need Steering Arms from a '76 b210 on my b110 so i can mount the 280zx struts. Right?

They B310 (210) Steering Arms won't work with 280Z struts. Instead, get 280ZX struts, which will work, and which have better brakes than 280Z.

I have never done the swap, but if you click on "Tech Wiki" under the Main Menu,
you will find "Modifications Contents". Click on the "Suspension Modifications"
link and you will find "280ZX Strut Swap" at the left upper side of page.
Hope that helps.

so the steering arms from the Datsun 210 should mount on the 280zx struts right?

The B310 is the US Datsun 210. I still see a few around. Check out Pick 'N Pull, or other self service yards near you. Good Luck!!!

so im just about to put up some pictures tonight, but i just had a quick question. I know that to put in some 280z struts on this i need a b310 steering arms, however i dont know where to get any. i live in Cali and i dont think i have ever seen a b310, Any help?