Browsing this Thread:
1 Anonymous Users
|
|
Re: E15/16 distributor conversion |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
Old roll-pin can usually be re-used as long as it goes back in tightly. Make sure the new drilled hole is exactly same size as A-series hole.
It seems to me Datsun didn't drill them exactly on center. But it is important to get them the right spot along the shaft so there is not excessive space between the gear and housing. They are two sizes washer for spacing.
Posted on: 2012/11/10 4:18
|
|
|
|
|
E15/16 distributor conversion |
|
Not too shy to talk  
Joined:
2012/9/4 10:14
From Woodend, VIC
Group:
Registered Users
|
I was just wondering how people have gone about drilling the hole through the E15 distributor shaft to install the a12 drive gear. Fairly important to drill directly through centre of shaft i'm assuming. Best done by a machine shop? Perhaps you just use a decent drill press and holding jig/clamp?
Also, do you have to provide a new roll pin or can you use the old one?
Cheers.
Posted on: 2012/11/9 22:38
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
