ok,

I know someone on here emailed me along time ago with dimesnions of brackets and mounting position for the r31 tank fitment into 1200 ute.

Can you please load the info up here or pm me so I can get the email?

Thank you my fellow datsun legends!

I dont have the instructions any more but i can take some pics of my r31 tank install if you want.

i want to see how far to the left it sits. I have a 3inch stainless zorst and a twin tip varex that I need to fit and thinking it may not fit :(

Cool, I'll take a few pics of my brackets installed but my tank is out at the moment cause its full of rust so i cant show you any pics of the gap for the exhaust. From memory it was very tight for my 2.5in exhaust but i am upgrading to 3in so once its built I will let you know how it goes.

heres some pics of the brackets.

I will take a few pics of the tank next so you can see where it needs to be trimmed so it will fit. Prolly do that monday if ya want.

Attach file:

---

  DRIVERS SIDE BRACKED.jpg (82.33 KB)


  DRIVERS SIDE BRACKED1.jpg (103.23 KB)


  PASS SIDE BRACKET.jpg (94.02 KB)


  PASS SIDE BRACKET1.jpg (95.96 KB)


  PASS SIDE BRACKET2.jpg (77.28 KB)


  PASS SIDE BRACKET3.jpg (78.80 KB)

That looks exactly the same as mine was!!! EXACTLY!
Due to getting mine engineered I can't run the fuel tank behind the axcel for some reason but il be doing a drop tank after I get it on the road. Fuel cell until then!
I have a blasted and powder coated black r31 tank that come out of mine with pump that I will no longer be using! Pm if keen

damn thats a small gap on the left... I have a varex muffler to go in there so i guess its a custom tank for me :(

Whats the go with the engineer not passing the tank behind the axle, seems odd is all. I might be keen on your tank as mine is rusted out but I am guessing shipping is prolly not going to be worth it to get it to sunny QLD.

Yeh bailz there is bugger all room on that side