+ Register
|
Main Menu
Login
Fast Search Slow Search
Google Ad |
Browsing this Thread:
1 Anonymous Users
#41
Re: my new ride 1200 ute
cadet1200
Posted on: 2014/2/23 3:13
Great progress. On the matter of clearance I'd be really interested to know the distance from the back of the Cam/rocker covers to the firewall using the Kev Rowley crossmember.
Are you going to run a heater...or don't you need one up there ?  
#43
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/2/24 1:44
cadet I'll measure it when I get it bolted down. it seems to sit a bit further forward than
others I have seen. No heater..12v hair dryers for mod plate:) ...and no cold idle either.
#44
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/3/4 10:25
took a while but automatic pilot bush finally out.
Motor should be in next week!
#45
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/3/15 9:41
Motor and gearbox in. Gearbox mount is 1inch out from where the l20 was. Still fits the original hole though. pics to come
#46
Re: my new ride 1200 ute
cadet1200
Posted on: 2014/3/16 0:22
So it cleared your existing clutch master cylinder OK?
Keen to see pics and also keen to get some measurements off you from engine to firewall using the K.Rowley X-Member.
#48
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/3/16 5:13
had to remove clutch master to install. We installed the gbox attached to motor otherwise it would have stayed in.
Plenty of room. I'll measure up for u tonight..
#49
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/3/16 6:43
just measured. engine is 4.5cm or 1.7inches from firewall
#50
Re: my new ride 1200 ute
mrbarista
Posted on: 2014/3/23 10:02
motor and gbox in
Attach file:  1978607_10152241192959724_212788421_n.jpg (44.44 KB)
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
|
