Well Harry, that's a relief. But I was trying to arrange finances if necessary for myself. I second the rear sway bar, & a half leaf fitted to the top of the spring pack. I did the half leaf to a Sunny Van I had, to get rid of wheel hop, it definitely did the job. Now the hilarious (ha ha) comment. Left hand drive. That'll get the driver weight to the correct side for Mt Cotton. It'd give you a great view down the hill, & get you away from the crunchy side after the finish line. Strange place, Mt Cotton, more accidents after the finish line than the rest of the track. Or, 2 steering wheels, one either side.
I picked up some cheap ($70) rear gas shocks on Ebay last week. Hopefully this is the short cut & they have some more.
http://www.ebay.com.au/itm/1814019668 ... eName=STRK%3AMEBIDX%3AIT.Could be what you want. Another no-name addition to the weapon.
Now, a question about that short rod/long rod L18. I've got some 86mm Z20e pistons with a raised pin height. does anyone know if I use an L20B crank in an L18 using L18 rods, will the Z20e piston work without too much machining. Would be good If it's close.