Hi Guys,
I am pretty sure this post has been discussed before. My appologies for reposting, was not able to find it.
I am restoring my 1200 ute with a stock A12 engine. Looking for some advice with EFI conversion. Is it expensive? is it simple? and is it worth doing it? EFI would probably be better with fuel but is it worth it?
Thanks again for all your advice/suggestion.
Kind regards,
Ron

Well if your goal is restoration then it must be carbureted, as EFI was never offered on the A12.

If you don't mind a modified vehicle, then EFI is cheap and easy (about $2500 + $500 for tuning)

Thanks DD, can A12 be modified for EFI? is it an easy modification? Has anyone in this forum tried doing it?

No mods are needed for EFI, just bolt the stuff on.

Then your ute will no longer be restored, which means returned to original condition.

Get this:

EFI Australia A12 manifold



Two of these:
EFI Hardware Australia



$260 manifold
2x $515 throttle bodies
4x $110 injector
$220 fuel rail kit
throttle linkage
fuel pump
return line fuel tank modification
surge tank
EFI-rated fuel hoses and clamps
EFI fuel filter
O2 sensor kit
TPS
MAP sensor
IAT sensor
Coolant temp sensor
Oil temp sensor
ECU $600 to $1500 - Haltech or Wolf or MegaSquirt, etc.
wiring harness

thanks dd, really appreciate your help.

That one is a work-in-progress, not available yet or is it?

It can be diy. He's tuned to na already. Just turbo to go

Wasn't there someone putting itbs off a 4AGE on one some where