Shorter. I did this for Turbo application and or Supercharger. I am making a set for my engine and figured while I was tooled up just make a few more sets to sell off.

I will send a set of the manifold and TB's to Simon for him to thrash.

that just looks like a Weber manifold with EFI throttle bodies on it,
not too bad on price,
I kinda like what Matt is doing,
I did simular a few years ago, Idea being, change the ends to suit, Single Weber, twin SU's, twin Webers, efi...

I like those!

Sweet design.

Nice designs there, Matthew have you looked a oval shaped TBs from Ducattis?
they are cheap on your side of the pond through ebay. Just a thought you could
use curved secondary from a weber manifold 2 into one big oval with twin inj.
They could run staged etc.
http://www.ebay.com/itm/Ducati-996-Du ... 996S-996SPS-/331774812166

another with singles
http://www.ebay.com/itm/Ducati-749-99 ... :-ksAAOSw7ThUkSBT&vxp=mtr

Here is the Rowland efi manifold more traditional looking but its better than
factory for flow as MR Rowland made sure of.

http://datsun1200.com/modules/myalbum/photo.php?lid=26377

Those are nice TB's

I had never considered Those to a weber mani.




These are still available on the AU weber site. $193.00 USD would be way less than my machine time.

Check out the Rowland offerings they are better value and available
in oval port configs as well. All 179aud posted to your door.
He has 3 A series mani offerings atm he used to have more




Another member is using this unit which has more volume than factory efi unit



http://www.manifolds.co.za/index.php? ... ry&category_id=9&Itemid=2

That last one is a Buffalo manifold, by Danie van Vuuren.

My apologies, was it made by Rowland though on contract?
http://datsun1200.com/modules/mediawi ... ex.php?title=EFI_Manifold