Was contemplating a simple single throttle body and plenum. Similar to what you have but with injector bungs on top .
injectors under the runners is not desirable - space and turbo heat, unless im looking at it wrong
dp

No imagine if you went injectors on the bottom it would be hot without a shield. I can design a plenum where the injectors shoot right into the runners.

Sounds good but what are we looking at price wise and it still needs to be posted.
Don't want you to go to all the trouble of design if its going to be 'price prohibitive'

Would be better if a few of us here wanted them?

Cheers dp

Zig I am machining these for $500.00 USD a set (without injection plenum), and I can post what the EFI version would look like without a Billet Plenum too. I can also run a 20% discount if we get 10 people solid on a buy. Money up front and in the mail within 4 weeks. Pictures of progress will be posted on the forum to keep people looped in.

A single package under 10lbs is usually 35-37$ USD for post.

OOOh sorry I'm out at over $750aus landed
Cheers dp

ITB's + turbo is doable but it's a lot harder to tune and probably not worth the hassle for the gain when you can just wind the boost up 25kPa more....

There is a casting foundry here in my town. I could see what a quote would be for cast intakes. I don't think it would be as inexpensive as the buffalo or billet in small batch orders.

The Buffalo was only $120 (2011 price)

Quote:

At double that is a good price. If only someone had a solid contact or could get them
Anyone?

At triple that Price id buy 3 just for simplicity 👍