http://datsun1200.com/modules/myalbum/photo.php?lid=24045&cid=14
I remember the 361005 being the stock length cart insert. I guess not.
Either way, I used the bilsteins because the koni's were too fat in diameter.

your's turned out good.

Hey ang.

what do you mean by the stock length cart?
the kyb strut i got was around 101mm shorter than the 120y(or 1200 since its the same front end strut/shocks) ones that i had ! :)

did you replace your rear shocks? if you did what did you use?

i flipped my rear leafs and its so low that now its on the bump stops haha. may have to cut some of it out.

and was this for your 1200 ute/sedan or b210/120y?

Angelo has a Datsun 1200

1200 Sedan, Coupe and Ute strut inserts are all the same. Same specs too. 120Y is the same, but USA B210 is totally different (uses the PB210 large-size supsension with 2.0 inch strut tubes)


Quote:How'd you do it? If you cut 100mm off the top, then the nut threads are gone. If you cut 100mm out of the middle, then do you need to weld the two halfs of the strut tube together?

Since the Golf inserts have a larger shaft, how did you get the lock nut back on? Did you drill it out larger?

The black cartridge says KYB, so is it the the one you put back in the strut?

Attach file:

---

  aWI9Tdm.jpg (185.08 KB)

Oh boy, I might have something mixed up regarding the black cartridges in my picture that I have labeled as "KYB 361005". I may have mixed something up on my end. I'll have to check it out.