Hi guys,

Does anyone have an old 1200 shell that they may be able to cut the front radius arm mounts from? I've had to repair some rust from the front chassis rail, but it turns out they are quite difficult to remove without damaging.

Any help appreciated. Happy to pay post worldwide if need be.

Thanks.

eBay Australia

When the radius rod mount cracked on my 1200, the bodyshop man (panel beater) made a new one out of sheet steel, he said it was quite easy to do. As I recall he added large washers where the bushing fits

Kalula bought these new from Nissan in 2007



now discontinued by Nissan North America
54532-H1001

Thanks mate,

I've contacted a few different suppliers to see if they have any old stock. I thought it might be a better option than trying to make them. Upon removal, I noticed one of them had previously been repaired from cracking as well.

Hey mate,

this company might have them,worth a try.

Link bellow.

https://www.amayama.com/en?gclid=CjwKE ... A8zfu0oxFWgHc4hoCiVDw_wcB

Thanks mate. Looks like they may have them. Is that place legit?

Yeah mate,

they are legit, I have bought quite a few things off them.

54532-H1001 BRACKET-SUSPENSION ROD, RH
54533-H1001 BRACKET-SUSPENSION ROD, LH