Sorry I haven't got a picture right now

But to try explain

They are a cylinder type shape, probably about 2mm thick wall
Perhaps 32-35mm diameter

The bottom end is cut square with the cylinder shape and a small notch cut out to sit over one of the nuts for wiper pivot bolt

The top side that goes to underside of cowl, is cut on an angle to the cylinder
To match the profile of cowl

I'm thinking I might have to make my own with some suitable sized black rubber tubing and a razor blade

Hey, thanks for reply

They are the wiper pivot rubbers

The ones I'm looking for are larger

They fill the gap between the cowl lower side and the plenum around the outside of wiper pivot

To get them in or out the wiper pivot must be removed

Then the rubber can be collapsed a little and eased out

I've not seen them anywhere apart from the one I had in one side

The rubber boots?




https://www.ebay.com/itm/Datsun-Wiper- ... 70494380?oid=231569294504

Hi All

Is anyone able to tell me where or even the name of the rubber part

Sits between cowl and plenum, water box area

Sealing around the hole where wiper pivot arm comes through the cowl

Checked the wiki, and not able to find a source to purchase new ones

I have one used one

Would like to get two new ones

Cheers