Browsing this Thread:
1 Anonymous Users
|
|
turbo camshaft Duration and valve lift lobe center? |
|
|
Just popping in
Joined:
2008/6/5 21:58
From Puerto Rico
Group:
Registered Users
|
Hello everyone, what kind of camshaft Spec. can I use in a Turbo A15 or A14 engine? It's my first time ordering a turbo camshaft is stock bore at: 9.0:1(135psi) compression Ratio Fuel injection reprograming ECU system turbo is 50/48mm. Thaks you for you Help
Regards, Dariel
Posted on: 2021/8/6 0:38
Edited by donditaa on 2021/8/6 1:28:41
Edited by donditaa on 2021/8/6 2:29:11
|
|
|
|
|
Re: turbo camshaft Duration and valve lift lobe center? |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
There are two kinds of "turbo" grinds: old school and modern. Old school makes 150HP from an A15, while modern can make 225HP
If you telephone a cam grinder you can get the latest information. For example fax Iskenderian at 310-515-5730
For old school, the Camtech A15 Turbo grind was 246/239 degrees advertised and 113 lobe separation
Posted on: 2021/8/8 1:18
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
