Will TRX wheels fit on the back if i have a ke30 BW diff?

yep...
what car is it on? if its a 120y the KE diff is wider and the tyre's may bump out on the guard under compression,
but i have seen trx rims on a ke30 sedan if thats what your asking...
the stud pattern is 114.3mm, but the trx wheel nuts may have a different thread pitch to the corolla studs meaning find some new nuts... hope i have... helped can someone confirm this?

sorry i didnt make myself clear, i have a 1200 sedan and i will be putting a ke30 diffi in it

The TRX wheels need a special Datsun wheel nut that has a 12 x 1.25mm thread.
Toyota wheel studs have a 12 x 1.5mm thread, so the two will not fit.
I do not know if the Datsun wheel studs will fit the Toyota axles

What about a 120y diff?

Quote:

they don't. the shoulder of the stud is larger diametre on the Corolla diff

are the special TRX lug nuts the same as the special 200B SX wheels? because I found the same type of lug nut to suit toyota thread pitch at my local wreckers when i used to run those wheels on my 1200 with KE55 BW diff. Unfortunately I have no idea what toyota they were off - I got them out of a box of toyota wheel nuts.

120Y diff is the same width as a 1200 diff, so you'll probably have clearance issue to inner wheel arch with the TRX wheels.

So, it looks like the Datsun stud will rattle around in the Toyotaaargh axle. That can't be good.

The special wheel nut is the same for the 200B SX & Aspen GL wheels along with the TRX Bluebird ones. All Datsuns of this era used the 12 x 1.25mm thread.

so i need toyots wheel nuts for back, but what studs do i need for the front?

thanks for your help

If you are using a Datsun front brake setup, then you need the nuts in the picture.

ok thanks mate