hi all,
i have read this from the tech session
but not so understand

i not sure if i ask before.

there is one wire comes out forom auto choke
where to connect it to?

my car comes with stock A12 alternator,
i not sure if it have build in regulator or not, how to check that out?

cause when i transplant to A15, only engine and carb is changed, the rest is the same, but the mech never bother to connect the choke for me

all this while i leave the auto-choke not-activated.

Connect it to the '+' side of the ballast resistor (or coil if you have no ballast resistor).

oic..
yea.. i located the coil
later i go check where is the "+" of the coil..
it is currently connected right? i have to duplicate the wire right?

There are two posts on the coil, they are marked '-' and 'minus' on the plastic part of the coil. There will be one or two wires already on the '+' side.

Get a length of wire about the same diameter as the choke wire, and connect it up.

thanks a lot
i will try that out.
really appreciate it

hi,
i got find that terminal already

now just need to find one Y lung and crimp it to a wire and fix it..

really thanks a lot