Hey all.

Well i have well and truely put this project to bed. The only reason i have is because im too lazy to fabricate a manifold and get it all running. And Dad wouldnt let me have a non running car taking up space in the garage anymore.

Quad motorbike carbies off a Honda CB750. Early 80s. 28mm choke. They were checked over and cleaned when i got them at a bike wrecker.

They should suit a mild A14/A15 or A12 if you sticking to the smaller bore. Just make a manifold up and tune and your set.

$200 ono
Located in Perth, Willing to ship.
I am selling for a 1/3 less then what i paid for them!

Anybody interested???

Make me a offer! Or trade something of interest???

hey quik q? How is and A14 /15 going to get enogh fuel from carbies that suit 750.

The motorbike they came off are OHC and a crossflow head design. they allso revv much higher then a A series (10k compared to 6.5k). Jets could easily be drilled out to accomidate more fuel flow. For these reasons the fuel rate is equiled out

Also how big is a standard A series carby? 20 and 21 venturi sizes or there abouts. These are quad 28mm so you have easily over 2ce the air/fuel flow into the engine.

if I wasnt going efi, I would have been intreested. These would have to be soo cool. hmm quads....

PM sent

He he just being a doodle i am in the final stages of my own setup lots of work but should be worth it!
Milking info for those that did not know already.

dan

Bump?

Just make a offer! I want em gone!!!

Beattie how much would it cost to get them up to me? I'm interested but it may not be worthwhile considering distance.

hey mate ill pay the 200 and postage if u would send it to northern nsw cheers