I took these a while back, the cams are marked as follows;

Lightened one - DE 84 & 5754

Standard cam - 16, M & 180







Can anyone tell me anything about these, they look almost identical except one looks like it's been cut down on a lathe.

Here are the two flywheels, the clutch disc is the same size but the pressure plate is different. Any ideas how to identify the plate needed if I want to run this one?









Thanks all.

I'm also feeling like a genius right now, I just finally figured out how to insert an image into the post

The relatively flat flywheel for for RWD A-series.

The flywheel with recessed "step" for clutch disk may be from a Datsun F10 (FWD Datsun).

So if I bought this I could take it apart & check it huh!




I'm curious if it'd be an advantage to try using the lighter one or it would matter much at all.

Any thought's on the cam's?

I was going to say that the cam has just been reground, but that sure looks like a lot of material removed for a regrind.