Can anyone help???
I was going to buy set of wheels with a
PCD of 114.3 - The wheels are off an RX7 S3.
Does anyone know if they will fit a 1200 too???

I know this site says a PCD of 114.7 or 4.5 inches for Datto's, but
4.5 inches works out to be 114.3 almost spot on.

Anyone used RX7 Series 3 wheels before?

Thanks...

Sam.

1200 PCD = 4x114.3
If wheels are 4x114.3 then they will fit the bolt holes. Weather the offset if right is another tale

Nissan specification is 4.5 inches, they used the British spec -- perhaps because they built thousands of Austins...

In any case, that works out to 114.3 mm.

Series 3 RX7 is FIVE x 114.3
Too many holes!

Series 3 RX7 is FIVE x 114.3
Too many holes!


??? Just going by what I saw on Ebay... There was a picture of a set of 4 simmons (with 4 stud pattern) and the add stated that he was unsure of what else they would fit but they had just come off his Series 3 RX7.

Series 3 RX7 is four stud, They didn't go to five stud until series 4.

Offset will be an issue though

Adam

Series III RX7's are 4x114.3, Series II & Is are 4x110.

All the early mazda stuff is 4x110 also like rx2 rx3. So Datsun people shouldn't lurk around on Mazda Forums, except to get rx7 550cc injectors.