hi i am just wondering if anyone had a picture of a crossmember with ca18det mounts welded on it. and the measurements of the mounts.

cheers

thanks mate but it doesn't have measurements.

Measurements!??
What are you looking for exactly,a full blown scale cad drawing so you can make a jig?

There is a guy in Brissy who might do one for you,but most guys bolt the drive train together,lower it into the bay on sky hooks and build the new mounts to suit,tack it together,pull out the engine,then mig the whole thing up properly

i was just getting a rough idea mate

If you really need measurements - Daveman says in that thread that he is happy to hand over the Solidworks files....which would have all the measurements in it.

Then you'd just need the software I suppose.

I'll happily hand over a solidwords file or IGES file. If you cannot open either of these formats I could dimension my model for you but will take me a little while.

My model is only as accurate as I could measure by hand. It's probably a pretty good start though.