EOI at this stage, don't want to sell them but trying to finish things around the place and fishing to see if anyones interested.

Will get photos tomorrow, under 9000kms these carbs are like new, still have factory paint on all balance adjustment screws etc.

Come with all mani rubbers o-rings and velocity stacks which have cost me an arm and a leg to source and buy.

Can come with L16-20 inlet manifold to suit.

PM me if interested.

PM sent.

So do those flanges match a weber manifold?

These are so nice, I've seen em' in the flesh! They even have ram tubes?!

I not sure but I will check hey, didn;t think of that, they normally bolt up to the head on the bike.

I had to search everywhere for the manifold rubbers and the ram tubes.. they cost an absolute #OOPS#e load.

hi,what price you looking at for those keihin carbs. nismo1

Hey Sean, did they fit? The bolt spacings look a bit broad for a weber manifold.

I didn't even have a chance to look, im going home in my dinner break to tape jamie oliver ha ha pig show so I'll have a quick measure then.

Hey Sean. Got ya PM reply but again i cant reply to PM's. Real keen with manifold if they fit it and will pay a deposit by Friday. Can you please Pm me a number maybe to call you on and chat more as well as your account details. Thanks Andrew

pm sent andrew

68mm between bolt holes on the mani rubbers... 78mm spacing between carbs 1-2 and 3-4, centre spacing is 87mm.

Does anyone have a weber manifold they can compare that to? It was too dark to see anything under the bonnet when I got home.