ok guys so i did have someone buying this engine but the sale fell through as he is now selling his car due to loss of licence
all of this setup can fit into a 1000/1200 engine bay with 0 molesting to the car its a bolt in and drive
so the specs are its fresh built its been run in and taken around the block once since built
its a non intercooled carby blow-through setup
new pistons
new rings
full gasket kit
all new engine bearings
holley 180 carb has been jetted
custom turbo manifold
ca18 t25 good turbo blows no smoke
custom dump-pipe
electronic dizzy
oil drain from turbo fitting added to sump
braided oil feed line
turbo cam (sounds tough on idle)
malpassi r/r fuel preassure reg
feul preasure guage
holley blue fuel pump
turbosmart bov
thats all i can think of atm but this setup has atot of potential it has not yet been dyno'd but the old engine i had in ther a14 which made i think 68kw atw but that engine was tired and that was b4 carby was jetted not bad for wot they come out stock

engine is in car atm and can hear running but car has no rego

reason for selling is lost interest in the 1000's atm and am building an sr bluebird as a track car

price i am looking for $2000 as this is a has cost me much more will consider swap for ca/sr engine/parts

any questions feel free to ask pm or call 0450342108

Attach file:

---

  a15t.jpg (78.86 KB)

Looks like Adelaide is ditching it's turbo's!

Sorry to hear the sale fell through Andy. How much is this bloke selling the blue thou for?

uhm he asking $3500 but will take $3000
maybe u want it chris?

Not for that much (the car that is).

It's neat but I don't have that money, didn't you hear me going on about my new shirt at your party?! I was flat-out trying to part with $20.00 just for the shirt!!Haha.

Nah, the engine should sell quick, cheers.

Chris

good offer....if near to my place im sure gonna buy that engine...too bad..its a longway from home...darn.

heya Andy, is that a J Pipe setup? or custom manifold.. can you swing up some more piccies.. :)

It looks like the intake is a standard manifold, but the exhaust setup is hidden.

Could be keen....

boosted Tuesday... ha ha

yes wen i get home i will try to get some more pics yes its a jpipe and its been custom made to fit with the standard inlet manifold
hope this pic works as they are all on my phone so i can send but i will try to post up

Attach file:

---

  a15 pic.jpg (60.60 KB)

and one from the manifold side please Andy.. :)