Hi,
If you can't make it - buy this one. 1200 to CA18 cross member, no engine mounts. Exactly the same as Maddat's - made by Kev Rowley (QLD).

Price: $300 ono happy to accept offers

Contact Geordie 0430 104 202

Attach file:

---

  crossmember.JPG (12.52 KB)

Can i see a photo of this fitted?
Is there littel rubbers between this xmember and the block or to another plate? Does it come with all bolts and rubbers?
Thanks

no engine mounts

Very over priced i would make and sell ya one for half that. Just send me ya cross member and cash/money order. Kev rowleys are not the same as Maddats either Maddat use heavier gauge plate for the mounts.

So this bolts strait to the block?
Im confused now.

With rubbers of course

rhys i have one come look

If its a Kev Rowley cross member then its designed to be used with the origional Silvia/180SX engine mounts

This is true - it is 'meant to be mounted with CA18 engine mounts' but I had this mounted using landrover mounts with no problems, no clearance problems either, top or bottom, sway bar etc. Only issue I reckon would be you'd probably get more engine vibration due to the mounts not being gel filled rubber. You can pick up a pair of used silvia mounts from SSS for $80 or less pending condition.

Open to offers of course.

But then again if Datscandy wants to cut up some cross members for half the price then go with that deal for sure! Couldn't imagine the gauge of steel being any thicker than whats on it...............

Just tryed to find what I paid for it as honestly I don't remember - 300 is high but I think it was 250 plus swap out my standard crossmember - anyway take it off my hands for 200 + postage. Hope that is easy enough for ya.

expensive roflamo, obviously you havent been to maddat.com.au ;)