just looking for a radiator for the sr20de conversion. have checked ebay and just wondering if anyone has used any of the SR Alloy ones around the 200-250 mark?

are they any good?...and how do they fit in a 1200?

I'm going to try one when I'm ready.
I contacted one of the sellers off Ebay a while ago and asked if they make custom sizes and they did. This particular one was going to charge $400 for a custom sized rad with a few mods (angled outlets and temp sender threaded holes).
Seemed worth a try to me.

i have one, they do fit but as for performance i cannot say as my SR isnt running yet

Which one did you purchase?...i was looking at the fenix ones any ideas of whats best?...

not sure on brand i bought it 2 years ago but i have sat it in place, requires a little modding to secure it, its cheapish and should be effective otherwise i think maddat does radiators to fit.

I have a Golpher brand in the Race Car(CA18 det)and could not be happier.

I have used two different SR20DET radiators bought from Ebay over the past 5 years (32mm and 50mm thick). Both worked fine.

Shoota77 which one did you talk to. they might beable to help me with a radiator upgrade on the cherry.

I have a FENIX one in the CA18 Ute. I have only warmed up the motor once.

Mine was for an RX7