Hi all I'm looking to buy a crankcase breather pipe in this style

Attach file:

---

  2546.jpg (87.16 KB)

Put a drag hose on it and plug your intake. You dont need to put that crap back into your cylinders. 👍

I'll be running it to a catch can. We have to for engineering but I wanted that pipe to do a short section of pipe then an AN fitting

Just use a section of 1" radiator hose.
I just plumbed mine into my exhaust. The exhaust flow sucks any blow by in the crank case out the tail pipe.

How I connected mine to catch can was to REMOVE the pipe, and I used copper plumbing fittings with exhaust system sealer for set it in place. If needed later, it can be knocked out again, but will semi-permanently stay there


Benny tapped the hole with a M22 tap and used a screw in fitting


So the stock Datsun 1200 breather pipe is straight


This can be cut shorter and a rubber hose connected to a fitting. Can use the stock breather hose cut short and an AN fitting with adapter down to smaller size

many B210 & B310s have right-angle Breather Tubes