hi noltec do make a set part # n44016S but they are costly so i made my own from diagrams on this site,in tech section .all material to do job cost me $60 australian and about 8 hours work ,they ftted with a little massarging of inner tower and give up to 4 deg - camber.
top plate was 10mm alloy bottom plate was 8mm mild steel.

SLY OLD FOX.......

Yea they are hard to find. I think that i will have to make one fit or just fab one up myself. I figured it was worth asking.

510 is different. stuff exclusively for the 310 is not easy to find in the states.

yea i do mean B310

When you say 210 are you referring to the B310, known as the 210 in the states?

I just fitted some datsun 1200 strut tops to my B310 (sunny), and they had to "massaged" to fit. The space on the inner edge of the tower is smaller on te B310, so I had to trim the strut tops to fit.

The other you may want to check is the postitioning of the three locating bolts. On the B310, there are two bolts on engine side of the tower, the 510 has one locating bolt on the engine side with two on the "fender" side of the tower. So they may need even more massaging to get them in.

Will a camber plate from a 510 fit a 210? Please help