reply sent

pm sent

alrighty folks I have just listed it on ebay if anyone is interested

http://cgi.ebay.com.au/ws/eBayISAPI.d ... PageName=ADME:L:LCA:AU:11

Hey Blofly, sorry to here that ,But before you take off on your travels make sure to grab a few contacts and numbers. pop in while your in Qld if you travel out this way .

i posted a link to this thread in the WA section for you.

yeah 8k is plenty...the power drops off at 7400 rpm...so no use revving it much past that.

9-10k revs are quite possible in an A series, but youd want to make sure that you change your main bearing cap bolts after every race meeting...cause the stretch and are prone to fracturing.
Yes this engine made 106rwhp which would be around 150hp pretty much on the 100hp/litre Zane is quoting.

alrighty I have advertised on ozdat but am waiting for the add to be accepted and I advertised on datnet here http://www.datnet.org/forum/viewtopic.php?t=6846

when I spoke to craig about this motor he said it makes over 100hp per litre of displacement which is pretty good in anyones sense and I believe the engine could rev to 9000rpm but I was only planning to rev it to 8000rpm if I installed it just to give my self a buffer in case I missed a gear

what can you rev an engine like that to?

i have heard that people have built a series motors to rev to 9 grand that seems a reasonable price, but i don't have that much money to spend at the moment.

make sure you put this on OZDAT and DATNET.

what????
Thats a shame Zane, I was really looking forward to see the engine scream in your car. Hope you get better too, that injury sounds nasty.