+ Register
|
Main Menu
Login
Fast Search Slow Search
Google Ad |
Browsing this Thread:
#4
Re: Sr20det four wire cam angle sensor - What wires are which signals?
LAGWAGON
Posted on: 2006/5/2 8:25
yeah, i had to get my CAS disk modified to have my wolf 3d wired up. just needed a hole drilled just before cyl1 i think. can't remember as it was a while ago.
i need this info too if anyone comes up with it...  
#3
Re: Sr20det four wire cam angle sensor - What wires are which signals?
dattodude
Posted on: 2006/5/2 1:03
So, have you installed the CAS disk yet?
I don't believe the SMC supports the 1degree signals out of the Nissan-factory units. The rest should be easily determined using the SR20 factory workshop manual PDF available online.
#2
Re: Sr20det four wire cam angle sensor - What wires are which signals?
B210sleeper
Posted on: 2006/5/2 0:47
throttle position sensors typically have V+, signal, Ground.
some want +5 and give a range, some want +12 and give on/off. the signal is usually the center wire and may have shielding on it.
#1
Sr20det four wire cam angle sensor - What wires are which signals?
JasoNDMX2
Posted on: 2006/5/2 0:37
It's a hitachi cas on a redtop
has a small (like 20 gauge) black wire black/white 18 gauge black 18 gauge white 18 gauge also the throttle position sensor Green/orange wire kight green wire red (with pink band- signal wire?) I am wiring these to an autronic SMC and it is calling for trigger supply reference trigger i/p cylinder pulse trigger i/p throttle position supply throttle position input
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
|
