lefty loosy righty tighty!

ha ha ha she told yuou mate lol

Quote:

hey smartass, if i realised it was your log in i would have logged into my account you know that that way no "stupid" questions will make you seem unknowing..remember this is my first project and i am better just with engines, even you agree i am better and know about the general working of a engine then you!! i seem to remember one saturday when i was working at the garage, you told me i was turning the oil filter the wrong way when i knew i wasn't it was just tight and kane had to tell you i was right.....:) but still luv ya!

lol at whorida

I can't believe she used my login to ask that Q, I told her from the start this is what we'd have to do!

Thanks boys.

Pics up for Wardy

Or u could have gotten it sand/bead blasted.. i got my engine bey, tub and both doors done two weeks ago for $200 saves a lot of time.. only took half hour

http://i149.photobucket.com/albums/s4 ... oute-1032007002Medium.jpg

http://i149.photobucket.com/albums/s4 ... oute-1032007001Medium.jpg

Wardy

I suppose I should have linked this picture instead.....shows the engine bay.



It's on page 7 of the evilbetty thread
http://datsun1200.com/modules/newbb/viewtopic.php?mode=viewtopic&topic_id=22424&forum=1&start=120&viewmode=flat&order=1

paint stripper is your friend mate. use him well. also lay a sheet of plastic under hte car also(just for the mess) then scrap it off with a metal scrapper. does this about 2-3 times then the rest use a wire wheel.

nothin wrong with a wire wheel on a lekky drill