as pepper said when putting back in i went to hardware and brought few meters of blind cord soak it in oil so it slides easy push into seal where body would sit and overlap rope top or bottom have some one hold window on outside in position with rubber in place as close as possible with them pushing start to pull string to lap rubber over the body once half way round grab the other end start the other way as for removing tint put some dishwashing liquid in spray bottle fill up with water keep window wet lot easier even more so when it comes to getting the glue of you will need couple off blades to make it easy hope this helps

Yeh kinda does actually, cheers for that. I will try and remove the tint with the window still in but if its a pain in the butt then I will just remove it.

to take out i used a couple of flat screwys, but carefully pushed the seal back out over the lip most of the way around until it came out easy.
to put back in, get some of that yellow and blue rope, stuff it into the seal, sit the glass back into place, get inside the car and pull the rope through. as you pull on it it will bring the rubber back over the lip.
make sense??

hi there if its only tint u want of u dont need to take the window out just use the blade around the edge cheers

Awesome, I love little hints and tips that save me blood sweat and tears (and coin)

got no idea i would say use the blade to start the tint off then it should pull off as a sheet hopefully, all i know is it can be a bi7ch to get off

With a stanley blade make sure its brand new and use some water with it to keep from scratching the glass.

Cheers dude. Since your on a question answering roll how about an easy method to removing tint. I plan on using a stanley blade and elbow grease

cant really help on puting it back in but yeah i would say just do the oposite youll need some window goop aswell. i think supa crap sells window getter outa thingies for 20 bucks or so, but screwies worked sweet.

one screw driver lifts the window away from the rubber the other puishes the rubber to the other side (like puting a tyre on)

cheers, might give it a go.

How about installing it, just do the opposite.

All I want to do is remove my crappy tint