Datsun 1000 kb10 is the drug let me now thanks

I made my own soft mounts. Glued some offcut Converyor belt rubber to a sheet of 4mm plywood. Sat a battery on it overnight so it stuck well.

I then chalked a pattern on cut the bits out with a jig-saw and then I touched it up with a 4 inch grinder and a grinding disc (to get to all the hard to get to bits).

Worked a treat. Conveyor belt is durable as, hence the choice. I may have a picture somewhere.

I found these but I don't know who makes them or how good they are:

http://www.efihardware.com/products/c184/Nissan-Datsun-manifolds

Yeah,thought that was a load when you put it up,funny how the guys got no stock and can't get anymore.

Your basic Redline will cost around $300.00 then you have to make them fit most times.

no joke!!!
yer got rooted around a bit but wat can ya do....
umm i think ill go see anthony at grand auto for the manifold and linkages n stuff i look on ebay i no ya can get soft mounts 4 of em are like 30 $ iv got lines so i shuld b all good. really sory 4 getin all yr hopes up high
cheers

I agree call stewart in sydney he makes great quality manifolds.

Haha, Too good to be true aye?

Or did you get the run-around?

Check out stewartwilkinsmotorsport.com they sell the GX manufactured manifold, no linkages though. Not sure where you would get all them from.

I would suggest you purchase from Bprojects Japan, their Australian Representative is Dundee1000 aka Mike.

The kit is complete (linkages, gaskets, softmounts, fuel line etc) and very well made.

rang the guy just b4.....
bad news lads , his out of stock!!!
cant get any more either sorry 2 let u all down ayy.
if i find some more ill let ya all no
lol 2 the picture below!
cheers

this is bat country

"LET ME NOW THANKS!"