So if the shaft that holds and turns the butterflies wobbles, what do you have to do to fix it? can you just rebuild the bearing or is the webber a through away?? Please help!!!

Uhm the bit that the accelerator cable hooks to and spins wen accelerating
That bolt if u hold it does it woble or have any play in it cause I just recentle had a weber and that bit wobled and would click so it caused it to idle heaps high in one spot and low in the other so wen u released the accelerator sometimes it would go back properly others it wouldn't so u couldn't use

I have had another look for vacuum leaks and started it again seems to run ok when you give it some gas but still dose not idle unless you hold you hand completely over the intake letting only a tiny bit of air in and even then idles really high. is there any paticular spot where vacuum leaks occour most or is something else wrong? please help i just want to drive!!!!!

sounds like a vacuum leak....
not sure on the jets though...

Just wondering i have searched everywhere to try and find out what i need to do to get my webber 32/36 running on my A12. i have had it on there and it will not idle unless you have your hand partly covering the intake.

I have checked the jets out and there sizes are:

Idle - 60/50
Main - 140/140
Air correciton 175/135

What do i need to change to make it idle beacuse from what i have found this set up should atl east idle before minor changes to tune properly.

Any help would be greatly appriciated.