yeh no worries :)
every panels been replaced on myne so prob dodgy workmanship when they were made no doubt

It's either a problem with the quality of the thai ones, or laziness on the part of datsun/nissan to clean up that area of the bodywork during assembly, as the inner frame overhangs a bit where it's spotwelded. It was the same on a couple of utes i looked at.

Cheers
Dave

yerp
thats what i ment lol
u fitted tai tailight panels and yeh
thank you both :)

hey mate.

when i fitted thai ones to my ute i had to remove a small amount of metal from the inner frame that the light bolts through, where it folded out and met the outer rear quarter.

it was stopping the taillight from sitting in properly, only about 4mm. I just filed it until it didn't interfere with the light.

where the red circle is:
































Cheers
Dave.

cheers mate
yerp fit the same as those baha
i just thought the tailights groove was to fit the tailight in flush
but yeh dw i understand its just a body line
:)

see these photos








Tail Light - Pickup

i searched and only came up with clasafieds
umm just wondering if genuine tailights fit up better then tai ones
because myne seem to bulge out more then usual and it looks quite stupid :S
there any ways to make these sit more snug
like folding the edge or something
thanks :)