I have 2 cams freshly ground in stock, 1st has .325cam lift/.470 at valve(big cam); 2nd has .302 cam lift/.435 at valve.With 1.44 rocker ratio. would also supply re radius lifter/followers. Both great cams (exchange std cam & lifters apply)if interested call me 0412 864 741 ernie

hhhmmm i want at least a 1/2 inch lift ,but it isnt very streetable ! but who care about streetablity ?

im in for a cam if there is enough interest in perth

there should be a few people that still make em...i know they still make the L series.

Crow told me they dont stock new cams for 1200 anymore.

it might even be better to get a hole new cam off of crow cams or something....cant remember who i went through to get my L series cam ground

if it helps i can organize to get regrind over here sdyney nsw. just need engine specs, type of use.post wouldnt be much. may even have 1 in stock. cheers ernie.0412 864 741 ring me

Ok so from what ive heard southside have bought the gear and the masters but havent got their #OOPS# together or arent the getting the right results for the $$. Has anyone had a cam done by them or had a cam done over east?

Southside engine centre ended up with all Camshaft engineerings stuff when they closed down

they bought the grinders and masters from CEC, (so Southside Engines it is)
if your getting some done,post it up here mabee we could get a few dat ones done in a group buy and then they could leave the machine set up...

dazza1200