Using A14 oval port.. Decomp plate you can a standard Alloy pressed one from any decent engine rebuild shop.. Computer is an OLD wolf 3D with Hand controller sensors are the usual crank, air, fuel, temp ETC.

hey what head are you using? and where did you get your decomp plate? i've got the same set up that i'm putting on a A14 but don't know how full on to go with the rebuild. My ute is already injected and turbo but the set up is quite ruf so going to build up a new motor to drop in. what computer are you running and what sensors? sorry about all the questions ha ha

Hey Frank.. haven't Driven it since October cause gearbox center plate mashed itself.... So was lucky i pulled it down.. Put a 1.5mm decompression plate in it aswell. Will be interesting to see what figures i get... ported the Head some more aswell

looks good when cleaned up. did you notice the power difference when the piston cracked

yes just in time... nice manifold mate.

Thought it was time for a freshin' up... Just in time too..

Attach file:

---

  017.JPG (161.18 KB)


  030.JPG (136.17 KB)


  009 (2).JPG (187.97 KB)


  026 (2).JPG (194.67 KB)