that setup would have been fun :P

There are 2.5 and bigger ones also!!! but custom made by a company that was online recently but cant find the link. They where in Victoria somewhere supplying Bentley and others.

Thats a big SU! never seen one that big before, not that iv'e looked

Its more like you see on V8 kits and if anything I would have mounted it a tad higher as it misses the bonnet by far and best to keep it away from he exhaust as much as possible so you dont need to run all that alloy insulation.

Also I wonder if a compact flat slide carb could be used instead of an SU carb.

An in all its a really clean install.

I would say it is a sharft with a bearing supporting it a each end

looks like it has a custon setup on fron and looks like some one has mad all the brackes nicely

http://datsun1200.com/modules/newbb/v ... t_id=42587#forumpost42587

Just wondering what happened to this beautiful setup and who or what kind
of front pulley support is has. It looks so good I want one instead of mounting
the supercharger so far forward this looks off the scales.