i hav 13" x 7 watanabe's on the front of my ute.. and my centre bore is 65mm and i had trouble getting the wheels to sit right. so i put some 6mm slip on spacers and they are all good :)

so im guessing you should be ok with a 75mm centre bore.. i suggest you try b4 you buy.. and if you use spacers put some lock tight on your studs just 2 be safe. or get longer studs.

hope this was the answer u where looking for.. good luck. :)

Datsun 1200 uses a common wheel bolt-pattern: 4 bolt holes on 4-1/2 inch circle (aka 4-on-4.5). Nissan engineers measured this in inches. In metric, this is equivalent to a 4 x 114.3 PCD (Pitch Circle Diameter

hope that answers your question

the wheels are 13inch and the centre bore is 75mm with the 4 bolts.. will these fit my 1200 ute?