I can get the brackets drawn up and cnc cut and folded but to do the whole kit on ebay would be to expensive to sell.
Probably end up costing $75 cost price for kit.
Be cheaper to get a kit from ebay for another model and just make a few brackets out of angle iron.
Ebay listing fdor commodore strut

I can get the drawings for the other brackets and post them on here.

I'd be keen on the lower and upper bracket if you can make some up! The upper bracket in the pic isn't quite long enough to span both bonnet bolt holes.
You could sell a kit on ebay and make some $$

Finally found a photo. It was the boot stay instead of the bonnet -- ratcheting version

Attach file:

---

  B10 trunk lid stay.jpg (82.68 KB)

I can get the bottom brackets CNC cut and bent. I haven't got a quote on on these exact bracket but it should be around 5-6$ from the company we get or shed brackets through. If any one is interested let me know.

Bracket 1158.06 $5.45 each
http://www.ovesco.com.au/products/gas-struts/gas-stay-brackets/

Series 8 Gas Stay 315mm
Card # 1146.24
Part # 3150200
strength 200 newton
Stroke 120
Diameter 6-15
$24.90 each

Attach file:

---

  1158.06.jpg (16.65 KB)


  1158.06_Dimensions.jpg (25.57 KB)


  series 8 gas stay.jpg (7.28 KB)


  series 8 gas stay Dimensions.jpg (22.53 KB)

The strut has the numbers 3140200 and 11.46.24
The black bracket is marked 1158.06 from the same supplier
the bottom bracket is the result of some 50x50 duragal angle and a angle grinder.

I should have got the bracket for the bottom made up with a 5 degree kick to it so it was on centerline

That looks good. Yes, please list the part number

I can get a part number. I only put one side on but it really needs two or a stronger strut.

Hey looks good, that is the only 1200 I've seen done up like that. How long is the strut or do you have the ovesco part #? Did you do both sides or does it work with just the one?

Attach file:

---

  45067928331_0990045d18_o .jpg (101.45 KB)

I made one up from a gas strut meant from a tool box.