haha i love it

Here is the supercharger inlet manifold plan

Attach file:

---

  manifold2..jpg (64.30 KB)


  supercharge.JPG (75.90 KB)

http://datsun1200.com/modules/newbb/v ... id=361345#forumpost361345

Poor mans BOV and supercharger backfire device on MG engine (similar engine to J series)

Bumperettes are superlight and made from damaged
bullbar alloy (very thick), took me a while to
figure out the shape but the first is perfect
just needs polishing and support welded up on
the rear for original bumper brackets.

Attach file:

---

  bullbar.JPG (91.88 KB)


  bumperet.JPG (95.09 KB)


  bumperette.JPG (199.45 KB)


  bumperettein.JPG (199.43 KB)

alternator upgrade, internal fan and regulator + 65amps
Best to use original 1K bracket on left rear section cut up and
add metal plate with holes as illustrated in yellow.

Instead I went the hard way and had Simon make me one from
2 1200 brackets as illustrated on right. Thanks Simon!

Mitsubishi alt from mazda 929 83-86 model many other mazdas
carry them in vans for example. part number on inset.

Attach file:

---

  4cm bracket.JPG (188.42 KB)


  altmitsu.JPG (128.87 KB)

I think theres more room in a 1200 hence the L series a much longer beast
fitting easier. At worst it would be easy to fit a straight brass threaded
tube it just that I had this one available at the time.
I used 2 pack steel putty to seal up the top breather and a thin bog layer.

That might fit a 1000, but is there enough room on the back for a 1200?

Todays lil progress shot

Attach file:

---

  blkrock.JPG (169.54 KB)

haha D yeah i thought the mail must have gotten lost somewhere and was going to just leave it til i got closer to attempting it to contact you again, cheers for the info ill have to give it a crack

Carbon fibre! so much for old school :)
pic of final black coat on and writing in silver chrome soon