What rust repairs, that's factory

So I assume rust repair sections should be welded the same?
Can you do a continuous weld around a repair section on one side only?

I might have to do some more welding :)

I know you army guys are kinky, I was ready with my thermal lance

im suprised you got past the fish hooks and barbed wire

I lubed yours up nice and proper ziggy, yours warped from friction burns though.

I used same engineer demacoz. He prefered the spot weld method with mastic in between to prevent rusting.

My engineer said :

". Tunnel welding - Preference for spot welding but will accept 'chain' welding (1 inch welding 1.5 inches space between welds) welding to be on both sides of tunnel (top and underneath). "

you can have a look in my build thread (DEMAC's 1200 UTE)

mik is good with man tunnels

20 to 25mm overlap all round

Hi,

Im going to attempt widening my tunnel. I bought the maddat tunnel and im wondering if anyone has tips for installing the new tunnel. If anyone has engineer approval for doing it what were the requirements?

Cheers