oh and the angle and brace make for something like 700kg of force or something damn cad lol

two pieces of angle 75x75 150long and drill a hole in them float the motor over standard 1200 xmember and tack u can still use standard mounts or get/make new ones it takes about 2 hours to do and way easier then any others i have seen.

just remember the to put the angle so it adds a brace to the xmember plus with a good welder you will have no problems

i used 5mm plate too ..... have a look at my build thread "DEMAC's 1200 UTE"

think i used 5mm...coz mine needs to handle heaps of power

4mm- if only stock a series were even 2mm lol

yeah i made my own mounts, used 4mm plate

And they sit the engine kinda high from what i've seen. Not that hard to make the mounts, mine was just 6 bits of flat plate. Make the bit that bolts to the engine mount, sit the engine where you want, tack it in, make the rest to suit

just remember if you use maddats x-member i sure you have to change tranny tunnel to a bigger one, just ask them the right questions

Oh sweet mate, i had a look and its exactly what i need. An nahh not pricey at all when its all i need to bolt the motor up. Thanks for ya help reuby

for bolt in stuff contact MadDat motorsports
They stock a huge range of bolt in stuff for the 1200 ute.

Some will say they are pricey, but considering that all the engineering has been done for you, and they come as a bolt in operation and look the part, i reckon they arnt far off the mark.http://www.maddat.com.au/