I think from memory the front drums have two smaller wheel cylinders on either side.

probably a good chance... should have the bore size written on both, make sure they match. or maybe the wiki has the answer...

should have added that i needed the rear wheel cylinder. Got a box full of nipples here.


Or......just thinking, i have a set of 1200 ute stock front drums, do they run the same cylinders??????

Ill have the hardest stiffy if this will work!

at least the guy in the photo seems to be enjoying his snapped nipple

You really should treat them better

probably easiest to buy a whole new slave cylinder that comes with one on it, then you don't have to try and get the broken one out

the nipple itself would be a very standard part and any auto shop should have it, or get one at wrecker or off the neighbour you don't likes car....

So i was just about to bleed my rear drums on the ute and the nipple was seized and it snapped leaving the whole thread inside the drum which is #OOPS#ing gay cause i just paid for a permit to get the bastard registered.

Does anyone know the part number for this or know a place in Melbourne that will stock it?

Cheers,
Daniel