cheers guys i'll try them...

http://3mcollision.com/catalogsearch/result/?q=weatherstrip

make sure mounting surfaces are clean, use a wax & grease remover or something like Dawn dishwashing soap. No lacquer thinner or solvent wipe down

U need a rubberized glue, shoe glue works well

I think 3M make a glue, window rubber adhesive. You need to be careful with this stuff as its nasty and dries yellow, prepsol lifts it easy though. Once you get to stick it works well .

sorry to renew an old thread but found this using the search bar, it wasnt exactly what I was looking for, but thought I'd just bump this one rather than start a whole new thread...

Anyway, my question is, what is the best glue/resin to hold the new door seals on.
I have a 1200 ute (obviously lol) and the seal along the bottom of the door keeps hanging down and stickin out the bottom of the door when i close it haha, looks like the last guys used liquid nails or something lol
any suggestions...

cheers guys.

my passenger door has ebay ones phils place, not very good!

Id def go genuine next time

Nissan.... Can't go wrong... Might be expensive but hell its done pretty well to last for 20+ years so its cheap really ;)

scotts also list a lot of stuff that i know is different as the same thing

thinking of just getting whatever length of the seal that i need and making my own. think scotts was $14 ish per meter. which is a bit better than $70 a seal

what about scotts old rubber in huntingdale?
expensive but good aparently.

I'd avoid Rare Spares aswell, they insist that all window seals for a 1200 are the same.
Or maybe the cleaner picked up the phone when I called?!?!