ram tubes came with the throttle bodies, but fairly certain, efihardware.com list separate ram tubes, all diffent sizes

Please create a new parts for information on A15 parts. This topic is about EFI

Not sure if this is the place but, can anyone advise me where to get engine component, shells rings etc in the UK or europe, I have an A15 which I am rebuilding and cant seem to get bits over here.

Chris

did the ram tubes come with it or did you buy them from somewhere else? and if you did, where do you get them from?

take a trip to Africa or pay someone decent $$$

you say get an a14 egi manifold but..where do you get them ????

lovely work will be nice to hear it from all angles once its roaring!

in all honesty the flywheel cost me a couple of jokes while i watched my mate a machinst spin it in the lathe haha was pretty fortunate.and if anyone pays for postage i can do any flywheels down to that level of machining fot $50 each and would be happy too, the ute is gettin bodywork/fiberglass work done at the minute,also making a carbonfibre bonnet and hardlid, not going to bolt engine in until all body work is finished and ute is sprayed in the very same blue that the peter jackson ford sierras were that used to run at bathurst, which i must add glenn seton used to drive is parked next to my ute being restored.

Didnt see your comment :S.
Sounds like you got a pretty damn good deal from your mate, the engine looks immaculate, you'll have to throw a couple vids of it up at some stage ey!
Would you mind me asking what you paid to get the flywheel to that point?
I spent over 200 hundred on mine and had nothing near that taken off!!
The engine looks great, when does it meet the car?