They were a nominal +2, 0, and -2 degrees or something like that. Works well enough.

rollmasters ones are multi keyway on crank gear.(7)keyways -6,-4,-2,0,+2,+4,+6
one std hole in cam gear.
no longer being made.
may find someone with old stock, if your lucky

The Rollermaster ones are cheap, they are not precision, they just have two or three extra holes drilled, and you pick the one that seems best. You can do the same to a stock pulley.

Hmm, you might be a bit stuck.

Hmm easier said then done...
Need template and then can be few degrees out

That's about what they all cost. Especially with that precision of adjustability. If it is too much then drill your own one and use the factory one.

Anyone selling these in Australia?
I think paying $300 to land one in Aust is a bit steep!

Same cam gear is used by A12/A14/A15

Kameari sell one

Bprojects sell one, does not need new timing cover

Does anyone know where I can buy an adjustable cam gear for an A14.
I want the type that doesn't require a new timing chain cover.

Think they are made by Rollermaster???