so i simply take the lucky dip?

I have actually heard of places allowing you to return the product until it fits?

They're just service parts. We usually don't nit-pic too much on sevice service dies either. However, they do fit. The inspectors usually let things go by, on sevice parts, that they would not allow on the new cars.
I work in for GM/Toyota in the stamping and plastics departments.
New United Motor Manufacturing Inc

i think the problem with taiwanese guards is the molds they use wear quickly,so the first lot off are close,but each new pressing is further & further out.

because its like a lucky dip, sometimes they're spot on.. other times you get a dud and you spend hours trying to fit it up.

what do you reckons wrong with taiwanese, just out of intrest

theres a place near me (VIC) that does new panels, im not sure where they get em from

howdy....

anyone know any places particulary sydney...

after bonnet, quarters and front apron.... new original if possible, trying to stay away from taiwanese