Hi Guys

Yes i know,thanks for the advice now it is much better than earlier it is not so horizontal so much , if i can manage this for another 2 months that is quite enough for me later i will buy 2 main leaf and re fix it soon ,i must get this running soon as possible before x mas , i want to replace tire rods and front bushing etc etc too soon.most probably i will remove them tonight

thanks
regards
sumith

Attach file:

---

  6.jpg (84.40 KB)

bad idea. with the spring being too long or too far back, your rear spring hanger can't allow for the spring elongation as it compresses. It's going to have some very hasty ride and handling characteristics and shag bushes quickly, maybe even rip rusted stuff mounts off the chassis...

Hi Guys

Finally There was no other option other than buying a main leaf but i am unable to spend 60$ on that since i have so many work on my 2 cars ,so i moved the center bolt an inch forward, now it right and center of it but leaf hanger is not vertical it is little horizontal that costed me 1$ only.

thanks
regards
sumith

Attach file:

---

  5.jpg (91.40 KB)

well if the spring is the right length, the only way for both the back of the spring to be that far back and the wheel to be that far back, is for the front spring hanger to be all #OOPS#ed up.

Hi Guys

Look at these measurements (all are Taken from the edge of leaf eye)

Front Leaf Eye to Center bolt 520 mm
rear Leaf Eye to Center bolt 640 mm

total length from edge to edge 1200 mm

thanks
regards
sumith

Attach file:

---

  front.jpg (92.31 KB)


  rear.jpg (84.60 KB)


  total.jpg (88.61 KB)

what's the distance from the center of front eye to the center bolt now?

Hi Guys

Since i have 5 leaf in this pack shall i take main leaf center bolt hole an inch or lesser to the forward i hope it will not break while running , any Ideas ?

thanks
regards
sumith

Hi

No Along the Leaf Spring only i checked, what i have fixed there is 155/80X13 on it

thanks
regards
sumith

your spring certainly appears to be longer than stock.



Are you measuring 1165mm along this red line?

it's not possible that your spring measurements are the same, or the wheel would be smack bang in the middle of the wheelarch like mine is. It's got nothing to do with the size of the tyre. 155/80 is pretty much the same diameter as the 205/60 on mine, but in your pics they look smaller - like the stock 12" tyres.

Attach file:

---

  SteveJonhs120Y2small.jpg (58.81 KB)