Got everything here the other day and DAAAAAAYYYMMM its nice!
So good quality, lighter than I had expected.

Here is some photos of the flares and the lip
Pics of them on the car then it is finished I'll try to get in here also, but if not hey will be in my build log.

1. The Flares are made of good quality, all hand made/pressed
2. They are 6-7 CM wide, so a overall increase of 12-14 CM.
3. Marked for placement
4. Only problem, one small handeling error / scratch in the paint.










As they are made of metal, they aren't as easy to "make fit" if they dont fit or need some massage. Have determined that I need to massage them a bit as they where made for the 4dr 120Y and not the 2dr. My fault that I didn't read the description properly :/ But they will do the work and look the part anyway

The Lip is 10-12 CM wide and attach with two mounting screws either end and a couple along the upper edge.





But we cant deside on the angle... But we are installing it as one of the least things, so when the time come we will se what fits the car

Ill post some pics when they get here!
But I Hey they Will Ship the lip if you contact them ;)

Yeah they look pretty good and being metal the flares could be welded on for a fully integrated look.

Funny though, it says 'does not ship to Australia' for the front lip, but they will send the flares!

Very similar to the factory Flares used on the Works PB 210 but in metal, somebody has gone to some trouble to make up dies as they are if metal quite nice pressings.

Hey guys :)

Just found on Ebay, I'm buying a set for my B210/120Y, but if anyone else where interested I would just like to share it with you!

http://www.ebay.com/itm/FENDER-FLARES ... 943a96:g:ce8AAOSwUuFWyd3g

http://www.ebay.com/itm/JDM-FOR-Datsu ... 943244:g:59UAAOSwPc9WyeCf

Looks to be quality stuff! and Looks good too